ANPR LUMO
| installation guide
29/39
7.3
ACTIONS
In the actions menu, you can define what actions the camera should perform on certain events.
There are three types of events based on the OCR system:
READ
When ANPR recognizes a plate
NOREAD
When there are no plates recognized between given limitations set under ALPR Configuration-Trigger (i.e. Start
and Stop trigger, or Start trigger and Trigger timeout).
WRONG DIR.
Wrong Direction occur when a new license plate is detected, but it moves in a direction which is not within
the allowed direction range defined for the area in which this plate is located.
LCR
Low confidence read event is created when a plate is read but the confidence level is lower than set in
parameter “LIMIT OF LOW CONF (%)”
For every “access list” you can define what actions the camera should perform when a plate is either matched or
mismatched on the concerned list.
The following actions can be added to any of the events, you can also make combination of actions.
Ftp Upload, Ftp Database, Store, Digital out, Serial, TCP, HTTP, WIEGAND26, WIEGAND64
For all actions you can define for which Area of interest the action should be performed. E.g. ALL AREAS or just one
selected AREA
7.3.1
DIGITAL OUT
This action will produce digital output for a specific time period
OUTPUT LINE
Which output should be activated 0=relay1, 1=relay2
INVERT SIGNAL
If enabled the output will become active
OUTPUT DURATION
The time in milliseconds that the output will be activated
NON-BLOCKING
if enabled other actions will not be delayed by this action