![background image](http://html1.mh-extra.com/html/nectre-fireplaces/nectre-15/nectre-15_operating-instructions-manual_3825464003.webp)
USER INSTRUCTIONS
3
1. GENERAL POINTS
Before use of this appliance please read these instructions
fully.
WARNING: ANY MODIFICATION OF THE APPLIANCE THAT
HAS NOT BEEN APPROVED IN WRITING BY THE TESTING
AUTHORITY IS CONSIDERED AS BREACHING AS/NZS 4013.
WARNING: DO NOT USE FLAMMABLE LIQUIDS OR AERO-
SOLS TO START OR REKINDLE THE FIRE.
WARNING: DO NOT USE FLAMMABLE LIQUIDS OR AERO-
SOLS IN THE VICINITY OF THIS APPLIANCE WHEN IT IS OP-
ERATING.
WARNING: DO NOT STORE FUEL WITHIN HEATER INSTAL-
LATION CLEARANCES.
WARNING: WHEN OPERATING THIS APPLIANCE AS AN
OPEN FIRE USE A FIRE SCREEN.
WARNING: OPEN AIR CONTROL (AND DAMPER WHEN FIT-
TED) BEFORE OPENING FIRING DOOR.
CAUTION: THIS APPLIANCE SHOULD NOT BE OPERATED
WITH A CRACKED GLASS.
CAUTION: THIS APPLIANCE SHOULD BE MAINTAINED AND
OPERATED AT ALL TIMES IN ACCORDANCE WITH THESE IN-
STRUCTIONS.
CAUTION: THE USE OF SOME TYPES OF PRESERVATIVE-
TREATED WOOD AS A FUEL CAN BE HAZARDOUS.
The appliance or flue system should not be modified in any
way without the written approval of the manufacturer.
Extractor fans or cooker hoods must not be placed in the
same room or space as this can cause appliance to emit
smoke into the room.
SERIAL NUMBER
This number is required when ordering spare parts or mak-
ing warranty claims. This can be found on the appliance
specification label on the rear heat shield
Refer to photo below for location of serial number.
AIR CONTROLS
Cleanburn technology and greater efficiency
The air spindle on the door controls the primary air to the
base of the fire. This controls the burn rate of the fire.
A tool for opening and closing the air spindle is supplied
with the heater. This can be used in instances when the
spindle control is too hot to touch. Alternatively, a glove or
equivalent can be used to adjust the air spindle.
A 2mm gap at the top of the door allows additional second-
ary air to enter the firebox, washing over the door glass
keeping it clean while also supplying necessary oxygen to
the fire when the air spindle has been fully closed.
If required, the 2mm gap can be adjusted by loosening the
two grub screws in the top of the door (high-lighted in photo
below) with the Allen key supplied, adjusting the metal strip
accordingly and re-tightening the screws.
DOOR HANDLE
Warning: door handle may get hot if appliance has been left
in High burn setting for extended period of time. In which
case use a protective glove or equivalent to open.
Open air spindle before opening door to eliminate chance of
backdraft.