This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
i)
Remove any old seal from the door.
ii)
Clean out the groove in the door that the seal was
bedded in using a flat-end screw driver or equivalent.
iii)
Run a thin bead of clear roof and gutter silicone along
the groove.
iv)
Starting at one end, press the new door seal rope into
the groove on the door.
v)
Refit the door if it has been removed and close.
If the door does not close firmly, then the door latch can be
adjusted.
In the front lower right-hand corner of the door opening,
inside the firebox, is a welded tab which the door latch
secures against when the door is closed. Using a large flat-
end screw driver, place it under the base of the tab and
gently lever it out.
Close the door with the door handle to test for any
improvement. If no improvement, repeat process until door
can be closed firmly.
Firebricks:
9 x full bricks – 234(h) x 118(w) x 40(d)mm
2 x triangular bricks – 70(h) x 58(d)mm
Baffle Plate:
440(w) x 260(d) x 75(h) in 6mm steel
Brick Retainer:
410mm x 345mm
Glass seal:
1080mm 8mm x 3mm
Glass:
333mm x 195mm x 5mm Pyro ceramic glass
Door rope:
900mm x 13mm round braided ceramic rope
5. FITTING A NEW DOOR SEAL
6. ADJUSTING DOOR LATCH
7. REPLACEMENT SPARE PARTS LIST