Setup and Operation 2-19
The electrical outlet is working.
The brightness and contrast controls for the display are adjusted properly.
All options have been properly installed.
NOTE:
If the system parameters (date, time,
options, etc.) have not been entered for the pres-
ent configuration, enter them when you complete
the setup procedures (see “System Parameters”
in this section).
POST Errors
Error messages will appear during POST when configuration information does not match
the settings stored in memory. Error message will also appear if the system loses the con-
figuration information due to hardware failure.
Refer to Table 2-4 for a description of POST error messages.
Table 2-4 POST Error Messages
MESSAGE
WHAT TO DO
Diskette drive A or B
failure or No Floppy
Drive
Drive A
does not work or is not properly
connected. Drive A is the diskette drive.
Check that drive A is securely connected and
power is on.
Press
F2
to start Setup to check the diskette
drive parameters.
If there’s still a problem, the drive might need
repair.
Invalid system disk
Diskette boot failure
Replace the disk and then press any key.
Insert a bootable disk in drive A and press any
other key.
Non-system disk or
disk error; Replace
and press any key
when ready
Remove the diskette from drive A and press
any key to start the system from the hard disk.
Or, insert a bootable disk in drive A and press
any key.
Operating System
Not Found
or
C: drive failure
Press
F2
to start Setup. Change the hard
disk type to the correct setting. Exit and save
Setup changes.
