NEC V850ES/Jx3-H, Руководство пользователя

Страница: 14 / 71

V850ES/Jx3H – Plug it!
3.1 SW1, Configuration Switch (DIP-Switch)
The different operation modes of the
V850ES/Jx3-H - Plug it!
board can be set by switch SW1. The bits
1-4 of DIP switch SW1 are for the mode setting of the board, bits 5-8 are connected to the pins
“P78/ANI8”, “P79/ANI9”, “P710/ANI10” and “P711/ANI11” of the V850 microcontroller and can be used
for user application purpose.
The
V850ES/Jx3-H - Plug it!
starterkit can be used in the following operation modes:
- On-Board debug mode
o
Start a debug session using the On-Board debug interface
- Flash-Programming Mode
o
Program an application to the build-in flash memory of 70F3760 by WriteEZ1-
programmer
- Stand alone mode
o
Run a program stored in built-in flash memory of the 70F3760 device
- N-Wire debug mode
o
Start a debug session using an N-Wire emulator, e.g. MINICUBE
SW1 / bit On-Board
Debug Mode
Flash
Programming
Mode
Stand alone
Mode
N-Wire
Debug Mode
1 OFF OFF OFF OFF
2 ON ON OFF OFF
3 ON ON OFF OFF
4 ON ON OFF OFF
Table 1: Mode setting, switch SW1
Note: After changing the configuration of SW1 bits 1-4 it is necessary to power-up the
V850ES/Jx3-H - Plug it! board to make changing active. This can be done by simply dis-
and reconnecting the USB interface cable.
User’s Manual U19647EE2V0UM00
14