NEC UNIVERGE WL, Быстрое руководство по установке

Страница: 30 / 34

1-24
UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
About Mounting Options
About Mmounting Options
• When you are mounting the UNIVERGE WL AP in the middle of a ceiling,
hallway, or ceiling plenum, you will typically use the color-coordinated
ceiling-mount base to stabilize the UNIVERGE WL AP after it is mounted.
Use the mounting base to mark the sheet metal, drywall, or other screw
locations.
The mounting base attaches to the bottom of the UNIVERGE WL AP with
two supplied screws, and then the assembly slides and locks onto two
sheet metal, drywall, or other screws.
• When you are mounting the UNIVERGE WL AP out from a wall (flat sides
along the room or hallway), use the projection-mount L-bracket
supplied with the UNIVERGE WL AP. Use the L-bracket to mark the sheet
metal, drywall, or other screw locations.
• When you are mounting the UNIVERGE WL AP against a wall (flat Side A
toward the inside of the building), use the flush-mount bracket supplied
with the UNIVERGE WL AP. The flush-mount L-bracket is the one with
one long and one short leg. Use the L-bracket to mark the sheet metal,
drywall, or other screw locations.
About Physical Security
About Physical Security
Regardless of mounting, the UNIVERGE WL AP can be secured with a Kensington
MicroSaver Security Cable. If required, use any MicroSaver Security Cable to
attach either side of your UNIVERGE WL AP to a solid beam, pipe, or support.
FCC Statements for UNIVERGE WL APs
FCC Statements for UNIVERGE WL APs
This section includes the following FCC statements for the UNIVERGE WL AP:
• Class A Statement
• RF Radiation Hazard Warning
• Non-Modification Statement
• Deployment Statement
Class A Statement
Class A Statement
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
NOTE
Because the UNIVERGE WL AP internal antennas have been designed to
reduce inter-floor interference, it is strongly recommended that you
mount the UNIVERGE WL AP standing or hanging straight up or down.
NOTE
You can mount the UNIVERGE WL APs in the ceiling plenum or below the
ceiling using the ceiling mount base or wall mount brackets, but the
UNIVERGE WL APs perform best when mounted below the ceiling.