NEC SV8500, Руководство пользователя

Страница: 1803 / 3438

VOL.2-1550
MG-SIP128 [MG-128SIPMGJ]
Note 1: The conditions of “SIP telephony service function” are as follows.
• When “SIP telephony service function” is enabled by the SET command “sip_tel_service”, “enable” is dis-
played, as well as enablement/disablement of the following settings:
Replaces function
Hold [a=inactive] function
• When “SIP telephony service function” is disabled by the SET command “sip_tel_service”, the following is
displayed:
“SIP telephony service function: disable”
Then nothing is displayed below “SIP telephony service function: disable”.
• The following is an example of display when “SIP telephony service function” is enabled by the SET com-
mand “sip_tel_service”. However, when “SIP telephony service function” is disabled, the following is not
displayed.
When Replaces function is enabled:
Replaces function
:enable
When Replaces function is disabled:
Replaces function
:disable
When Replaces function is enabled:
Hold [a=inactive] function
:enable
When Replaces function is disabled:
Hold [a=inactive] function
:disable
Note 2: This parameter is displayed since SP-4032 MGSIP PROG-E Issue 2.
Burst Access Filter :disable
When “enable” is selected for
“Burst Access Filter” by the SET
command “sip_accfilter”,
“enable” and the following set-
tings are displayed:
Burst Access Filter: enable
Burst Access limit timer value: 30
Burst Access limit number value:
500
Burst Access reject response code:
600
When “disable” is selected for
“Burst Access Filter”, the above
settings are not shown.
Note 2
-------------------------------------------------
set mp_mode:
Multipoint mode :enable
Number of Search Number digits :7
Server Select priority :Fixed
Currently assigned common con-
fig data of Multipoint Mode will
be displayed.