NEC SILENTWRIT 1700 Series, Руководство по настройке

Страница: 76 / 196

4–28 1765 Network Printer Configuration Guide
Establish the Printer on the Host Computer
You can print documents to the Silentwriter with either
the
lpr
or
ftp
command. Once the
/etc/hosts
file
contains the IP address and name of your Silentwriter,
you may use
ftp
to print documents. If you wish to use
the
lpr
command you must
1. Add the Silentwriter to the
/etc/printcap
files
2. Set up remote printing
Add the Silentwriter to the /etc/printcap File
The
printcap
file entry has the following form
<host name>:\
:lp=:rm=<host name>:rp=<filter>:
sd=<spool dir>:
<host name> is the name defined in the
/etc/hosts
file.
<filter> is one of the following filters:
lpb: No filtering. Use for binary files.
lpa:
Change LF to CR+LF. Converts the LF line-feed
code (0A) to CR+LF (0D0A).
lpbf:
lpb+FF. Adds the FF code (0C) to the end of
the file.
lpaf: lpa+FF. Converts the LF into CR+LF and adds
the FF code (0C) to the end of the file.
The default filter is
lpb
but for most print requests you
should use
lpa
or
lpaf
to ensure correct formatting for
the output.
An example
printcap
file entry is shown below.
NP015626:\
:lp=:rm=11.22.33.26:rp=lpaf:sd=/usr/
spool/lpd/NP015626:
Everything after the “\” appears on the same line with
no spaces.
Set Up Remote Printing
Execute the following commands to make a directory
for the spooler and enable remote printing.
mkdir /usr/spool/lpd/<printer>
lpsystem -t bsd <host name>
lpadmin -p <printer> -s <host name>
accept <printer>
enable <printer>
The host name can be the same as the printer name.
For example,
mkdir /usr/spool/lpd/NP015626
lpsystem -t bsd NP015626
lpadmin -p NP015626 -s NP015626
accept NP015626
enable NP015626