NEC SIGMABLADE Series, Руководство пользователя

Страница: 59 / 68

(English)
37
FC Connection Setting
How to Change FC Connection Speed [N8406-021]
The N8406-021 FC Pass-Through Card supports 2Gbps and 4Gbps connection speeds. All ports are set to 4Gbps
by factory default.
You can change the speed for each port via the EM Card Command Line Interface. To change the speed, enter the
commands shown in the section below. For detailed instructions for using the Command Line Interface, see your
EM Card User’s Guide.
How to Use EM Card Command Line Interface
Procedure Operation
1.
Log in to the EM Card
Enter the user name and password for the EM Card, and log in.
The “$” prompt appears on your console screen.
2.
Specify a Switch Module Slot for
log collection.
$ connectswitch –b 9600 –f none <slot number>
<slot number>
Slot1 and 2 … 1
Slot3 and 4 … 3
Slot5 and 6 … 5
The prompt letter changes to “user>” on your console screen.
For more information about the “connectswitch” command, See your EM
Card User’s Guide.
3.
The speed setting command is
input.
Enter the commands shown in the next page.
4.
Close the “connectswitch”
command.
Enter [CTRL]+ “m” (or “Enter”), and then enter “~.” (a tilde and period).
The prompt letter changes to “$” on your console screen.
5.
Log out
$ exit
z When the new setting is enabled, the port links are temporarily disconnected.
z
All ports are set to 4Gbps by factory default.