4 NEC PowerMate CT Release Notes
3.
Click the
Configuration
tab. In the Configuration display, the following protocols are
loaded:
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
4.
Highlight
NWLink IPXSPX-Compatible Transport
and click
Remove
. A warning window
appears asking for confirmation to continue.
5.
Click
Yes
. The NWLink IPXSPX-Compatible Transport and NWLink NetBIOS lines
disappear from the Configuration display.
6.
Repeat steps 4 and 5 to remove the NetBEUI Protocol.
7.
In the Configuration tab display, click
Add
. Highlight
Protocol
and click
Add
.
8.
Highlight
Microsoft
and then
TCP/IP
and click
OK
. The TCP/IP Setup window appears. If
there is a DHCP server on the network, click
Yes
; otherwise click
No
.
9.
Change the path in the window to
C:\I386
. Click
Continue
. The Network window appears.
If Yes was clicked in step 8, skip to step 16. If No was clicked in step 8, the Windows Setup
window appears.
10.
Click
Close
. The Microsoft TCP/IP Properties Box appears.
11.
Fill in the
IP Address
, the Subnet
Mask
, and the
Default Gateway
in the “Specify an IP
address” area.
12.
Click the
DNS
tab and enter the host and domain name in the DNS display.
13.
Click the
Identification
tab and change the Computer Name if appropriate.
14.
Click the
WINS
tab and enter the WINS address if appropriate.
15.
Click the
Routing
tab and enable IP forwarding if appropriate.
16.
Click
OK
. When prompted to restart the system, click
Yes
.
Changing Network Settings on Systems with Windows 2000
All systems are configured with the NetBEUI and NWLink protocols enabled. However, before
you connect a system to your network you might need to:
enable a different network protocol
disable unneeded protocols for enhanced system performance
add or change network, domain, and gateway information.
The following procedures describe how to enable TCP/IP and how to provide network, domain,
and gateway information. (If a different protocol is enabled, the menu choices might differ from
those described in the procedure.)
Network Type and/or Workgroup
Use the following procedure to set up a network type and/or workgroup.
1.
From the Windows desktop, click
Start
on the taskbar, point to
Settings
, and click
Network
and Dial up Connections
.
2.
Click the
Network Identification
hyperlink in the right window.
3.
From the System Properties box, click the
Network ID
button. The Network Identification
Wizard launches.
