NEC POWERMATE 2000, Инструкция по обслуживанию и справочник

Страница: 47 / 183

2-20 System Configuration
If you set the master and user password on a hard drive, you
can never remove the passwords. You can change the
passwords. If you forget the master password and install the
drive in another system, you cannot access the data on the
hard drive.
Once you set these passwords, NEC Computers Inc. has
no capability of removing them.
If you install the hard drive in another PowerMate system
with hard disk drive security enabled, you must enter the
password to allow access to the hard drive. If this
PowerMate system does not support hard disk drive
security, you cannot access the data on the hard drive.
1.
Boot your system. Press F2 when prompted to enter BIOS setup. The Main
BIOS setup screen appears
2.
Using the arrow keys, select the Security menu.
3. Highlight
Assign HDD Password
and press
Enter
. The system prompts
you to enter a master password.
4.
Enter a master HDD password and press Enter . The system prompts you to
reenter the password to verify.
5.
Reenter the master HDD password and press Enter . The system confirms
the creation of the master password and prompts you to enter a user
password.
6. Enter a user password and press Enter . The system prompts you to reenter
the password to verify.
7.
Reenter the user password and press Enter .
8.
Highlight and select Internal HDD Password. Use the + (plus) and – (minus)
keys to enable the selection. (This enables password protection for the
internal HDD.)
Changing Hard Disk Drive Passwords
Use the following procedure to change hard disk drive passwords.
1. Boot your system. Press
F2
when prompted to enter BIOS Setup.
2. At the Main BIOS setup screen, select the Security menu.
3. Highlight Assign HDD Password and press
Enter
.
!
If you enter the current master password, you are prompted to enter a
new master password.
!
If you enter the current user password, you are prompted to enter the
new user password.