NEC NP-02HD, Руководство по установке

Страница: 131 / 150

131
LCD Menu
[Sensor Calibration]
When installing the projector, measure the initial brightness of the light source and save the measured value into the projector.
Once it is saved, it is used as reference to display the current brightness as a percentage.
This function can be used when the projector is on standby.
Use this function only if necessary.
*The screen is an example of the screen of NC3541L.
← Pressing the ENTER button executes this function.
[S/N Maintenance]
Use the function to maintain the projector serial number when replacing a board in the projector during maintenance, etc.
This menu can be used only during standby.
←
Pressing the ENTER button executes this function.
[ PWB Replace ]
Use the function to maintain the data of the projector after replacing a board in the projector during maintenance, etc.
This menu can be used only during standby.
For details, refer to the service manual.
OPT MCU Use the function when replacing the OPT MCU board.
LD IF Use the function when replacing the LD IF board.
LU Info Use the function when replacing the LU Info board.
[LU Replace]
Use the function to maintain various data of the projector and the light module after replacing the light module.
This menu can be used only during standby. For details, refer to the service manual.
[LD Calibration]
Calibrate the light source to save light source adjustment data into the projector.
This function can be used only when the projector is on standby.
Use this function only if necessary.
← Pressing the ENTER button executes this function.