NEC NEAX IPS, Руководство по установке

Страница: 147 / 180

CHAPTER 6 MANAGEMENT AND MAINTENANCE
– 137 –
NWA-008869-001 Rev.1.0
atch6001.fm
CONFIG MANAGEMENT
Running config is retained in DRAM during operation, and is erased when the power to the In-Skin Router
is turned OFF. To start the In-Skin Router with the same settings the next time the power is turned ON,
therefore, you must save the current running config to flash memory as startup config. The data in flash
memory will not be erased even after the power is turned OFF.
NOTE:
In case that the In-Skin Router cannot start, save running config after you have confirmed the
settings. Config is information specific to the In-Skin Router, and if it is not saved, you will need
to reconfigure the In-Skin Router with appropriate commands from the start.
MEMO:
To check the settings with which the In-Skin Router is currently operating, you can view running
config with the show running-config command. To check the saved settings, you can view star-
tup config with the show startup-config command.
Saving with the write memory command
Executing the write memory command in global config mode causes running config to be saved as startup
config. Running config is written over startup config.
MEMO: To check that saving has been performed properly, use the show startup-config command.
Router # enable
−
config
Router (config) # write memory
Router (config) #
Enter
Enter
CONFIG MANAGEMENT