NEC NEAX IPS, Руководство по установке

Страница: 136 / 180

CHAPTER 5 EXAMPLES OF SETUP ON NETWORKS
– 126 –
NWA-008869-001 Rev.1.0
atch5001.fm
Setting the DNS server
Use proxy DNS. To use the DNS server address permanently, set the address as follows:
MEMO: If using proxy DNS, register the IP address set in the FastEthernet0.0 of the In-Skin Router as
the DNS server address to be set on this terminal.
To let IPCP automatically acquire the address of the DNS server, perform the following instead of the
above example.
Shutting down a PPPoE connection
To shut down a PPPoE connection, be sure to use the shutdown command. This causes a PPPoE discon-
nection sequence to be performed between the In-Skin Router and the provider-side access server.
NOTE: If you shut down a connection by turning OFF the power switch or by other means, instead of
using the shutdown command, it will take a few minutes to establish the next connection.
Router (config
−
Ethernet0.1) # exit
Router (config) # proxy
−
dns server ( DNS
−
server
−
address )
Router (config) # proxy
−
dns enable
Router (config) #
Enter
Enter
Enter
Router (config
−
Ethernet0.1) # exit
Router (config) # proxy
−
dns dynamic ipcp
Router (config) # proxy
−
dns enable
Router (config) #
Enter
Enter
Enter
Router (config) # interface FastEthernet0.0
Router (config
−
FastEthernet0.0) # shutdown
Router (config
−
FastEthernet0.0) #
Enter
Enter
PPPoE SETUP EXAMPLE