Smooth Operator Configuration Note (77175)
NEC Neax 2400 w/ Direct Serial Link
C o n f i d e n t i a l
P a g e 6
The above information is provided by Octel Communications Corporation as a guide.
See disclaimer on page 1
O c t e l C o m m u n i c a t i o n s
When programming a port, you may need to change the Tenant Number.
You will need to select and enter a proper Station Number and Line
Equipment Assignment.
Telephone Class
must be set to
3
. A Route
Restriction Class and Service Feature Class must be selected. There are no
known conflicts with the options in either Route Restriction Class or
Service Feature Class at this time.
Assignment of Station Data
TN:
Tenant
Number
TN:
1
STN:
100
STN:
Station
Number
LENS:
000000
LENS: Line Equipment Number (6 Digits)
TEC:
3
RSC: 0 SFC: 0
TEC: Telephone Class (1-31)
1-DP
(10PPS)
22-EMM
2-PB
3-DP/PB
11-VMM/VMZ
12-Dterm
V
13-Data Terminal Via Dterm V
14-Hot
Line
15-Cas
Line
RSC: Route Restriction Class (0-15)
16-Data Terminal via Data Module
For assignment of RSC, ARSC command 18-Virtual Line Appearance
SFC: Service Feature Class (0-15)
19-TMM
For assignment of SFC, ASFC command 20-PSM
When you are done editing the final field on this screen, press the
ENTER
key
to confirm the single line station programming. When assigning the first
station data command for a Line Package, the message "
PKG CHECK
" will
be displayed on the screen. At this point, check that the right circuit card is in
the slot on the switch and then press the
ENTER
key. All assignments to the
same Line Package, after the initial one, will prompt you with a "
WRT?
"
message after entering the station data. Type "
Y
" then press the
ENTER
key
to confirm your information. The cursor will then move to the first field,
allowing you to configure the next single line port. Repeat this step for each
single line port.
When you have configured all your single line ports, press the
\
(BACKSLASH) key to return to the Station Menu.
