NEC N8800-149F, Руководство пользователя

Страница: 73 / 226

ESX Operation and Configuration 3-7
Unused disks:
- vmhba110500:C0:T0:L0
(After verifying the isolation of the specified disk from the RAID configuration
(“after confirming that Unused disks” is displayed), replace the hard disk.
Wait approximately five minute before the system starts to resynchronize. If there
is no automatic synchronization, manually restore the disk with the below
procedure.)
# ./mpmadm -l
mpm0 [1/2]
|_ vmhba100500:C0:T0:L0 [ in_sync ]
(Check if the replaced disk is recognized by the system.)
# ./mpmadm -l
mpm0 [1/2]
|_ vmhba100500:C0:T0:L0 [ in_sync ]
Unused disks:
- vmhba110500:C0:T1:L0
(If the system does not synchronize in the replaced disk automatically, execute
the below command to restore to the RAID configuration manually.)
# ./mpmadm -a mpm0 vmhba110500:C0:T1:L0
Successfully added disk vmhba110500:C0:T1:L0 to volume mpm0.
(Check if the resynchronization process is started.)
# ./mpmadm -l
mpm0 [2/2] recover=0.6% (455808/71484736) finish=18.1min (65115K/s)
|_ vmhba110500:C0:T1:L0 [ syncing ]
|_ vmhba100500:C0:T0:L0 [ in_sync ]
(Perform restoration (RECOVERY) to each RAID devices (mpm). After a while,
check the Status with the below command. “syncing” shows to be in the process
of restoring.)
# ./mpmadm -l
mpm0 [2/2]
|_ vmhba110500:C0:T1:L0 [ in_sync ]
|_ vmhba100500:C0:T0:L0 [ in_sync ]
(When the each RAID device Status is “in_sysnc” and Raid device( mpm ) is not
displasyed, the RAID configuration is restored normally. This ends the disk
replacement procedure.)