NEC N8551-29F, Инструкция по эксплуатации

Страница: 8 / 56

viii
For Correct Operation
To operate the N8551-29F Built-In AIT Auto-Loader Unit correctly, observe the following points.
For considerations on handling the AIT data cartridge, refer to the chapter “AIT Data Cartridge”.
Main unit
• Set the SCSI ID of the N8551-29F Built-In AIT Auto-Loader Unit so that it is not similar to the
SCSI IDs of other SCSI equipment.
→
Otherwise, an operation error will occur.
• Before setting the magazine on the N8551-29F Built-In AIT Auto-Loader Unit, check that four
AIT cartridges are set in the magazine.
→
If the magazine in which only three or less cartridges are contained is set, a machine failure
or damage of the backup data may be caused.
• Do not turn off the power to the basic processing unit when the BUSY lamp on the front of the
Built-In AIT Auto-Loader Unit is ON or blinking.
→
This may cause a machine failure or damage of the backup data.
• Do not store the Built-In AIT Auto-Loader Unit in a place exposed to direct sunlight.
→
The Built-In AIT Auto-Loader Unit may not be able to operate correctly.
• Do not store the Built-In AIT Auto-Loader Unit in a place subject to corrosive gas, chemicals or
splashing of chemicals.
→
The Built-In AIT Auto-Loader Unit may get deformed or damaged and may not operate
correctly.
• Do not store the Built-In AIT Auto-Loader Unit in a place subject to strong vibrations.
→
This may cause machine failure.
• Do not put a load on the Built-In AIT Auto-Loader Unit when using or storing it.
→
This may cause machine failure.
• Do not store the Built-In AIT Auto-Loader Unit in a place subject to drastic temperature
fluctuations.
→
This may cause machine failure.
• Use the “AIT Data Cartridge (model: AIT2, AIT1)” as the Built-In AIT Auto-Loader Unit data
cartridge.
→
If you use a data cartridge of another make, a read/write error may occur.
• Use the “AIT Cleaning Cartridge” for cleaning the Built-In AIT Auto-Loader Unit.
→
If you use a cleaner of another make, a machine failure may occur.