Remote monitoring 83
3.
Apply, verify, and save the configuration.
RMON group 9 — events
The RMON Event group allows you to define events that are triggered by alarms. An event can be a log message,
an SNMP trap message, or both. The switch supports up to 30 RMON Event groups.
When an alarm is generated, it triggers a corresponding event notification. Use the
/cfg/rmon/alarm
x/revtidx
and
/fevtidx
commands to correlate an event index to an alarm.
RMON events use SNMP and syslogs to send notifications. Therefore, an SNMP trap host must be configured for
trap event notification to work properly.
RMON uses a SYSLOG host to send syslog messages. Therefore, an existing SYSLOG host (
/cfg/sys/syslog
)
must be configured for event log notification to work properly. Each log event generates a SYSLOG of type RMON
that corresponds to the event.
Configuring RMON Events (AOS CLI example)
1.
Configure the RMON Event parameters.
>> /cfg/rmon/event 5 (Select RMON Event 5)
>> RMON Event 5# descn "SYSLOG_generation_event"
>> RMON Event 5# type log
>> RMON Event 5# owner “Owner_event_5”
2.
Apply and save the configuration.
>> RMON Alarm 5# apply (Make your changes active)
>> RMON Alarm 5# save (Save for restore after reboot)
This configuration creates an RMON event that sends a SYSLOG message each time it is triggered by an alarm.
1. Apply
3. Save
2. Verify
