English-8
3. Installing and removing optional table
top stand
CAUTION:
Installing and removing the stand must be done
by two or more people for V552-TM, by four or
more people for V801-TM.
To install, follow those instructions included with the stand or
mounting apparatus. Use only those devices recommended
by the manufacturer.
NOTE:
For V552-TM, use ONLY thumbscrews which are
included in the monitor.
For V801-TM, use ONLY the thumbscrews which
are included with the optional table top stand.
When installing the LCD monitor stand, handle the unit with
care to avoid pinching your fi ngers.
Optional table top stand
Table
Protective Sheet
NOTE:
Install the stand in the direction of the arrow which
is imprinted on the surface of the stand.
Use the ST4620 for V552-TM, ST-801 for
V801-TM.
NOTE:
V552-TM only: DO NOT use this monitor on the
fl oor with the table top stand. Please use this
monitor on a table or with a mounting accessory
for support.
4. Ventilation Requirements
When mounting in an enclosed space or recessed area,
leave adequate room between the monitor and the enclosure
to allow heat to disperse, as shown below.
Allow adequate ventilation or provide air conditioning around
the monitor, so that heat can properly dissipate away from
the unit and mounting apparatus; especially when you use
monitors in multiple screen.
NOTE:
The sound quality of the internal speakers will
differ according to the acoustics of the room.
Mounting accessories can be attached with the monitor in
the face down position. To avoid damaging the screen face,
place the protective sheet on the table underneath the LCD.
The protective sheet was wrapped around the LCD in the
original packaging. Make sure there is nothing on the table
that can damage the monitor.
When using mounting accessories other than NEC compliant
and approved, they must comply with the VESA-compatible
mounting method.
NOTE:
• Do not leave the monitor in the face-up or face-
down position for more than one hour as this
may result in a negative effect on the screen’s
performance.
• Prior to installation, be sure to place the monitor
on a fl at area with adequate space.
2. Using Option Board
1. Turn off the main power switch.
2. Remove the attached slot cover by unscrewing the
installed screws (
Figure 1
).
3. Insert option board in to the monitor.
NOTE:
Please contact your supplier for available option
boards.
Do not apply excessive force to manipulate the
optional board before fi xing it with screws.
Figure 1
