NEC MultiSync UX552, Руководство по установке

Страница: 11 / 25

Eng
lish
English
- 11
6. Wall mount brackets installation
(1) Use only mounting brackets that comply with the VESA standards.
(2) Install the display only after thoroughly checking the strength of the mounting surface.
(3) Use mounting brackets strong enough to support the display.
(4) Check the strength and other safety factors before installing the display.
(5) Refer to the mounting brackets manual for details on the mounting method and on how to guarantee the
installation safety.
(6) When using M6 screws, make screw holes of 8.5 mm or less in diameter.
When using M8 screws, make screw holes of 10 mm or less in diameter.
(7) Pay attention not to leave any gap between the installation surface of the display and the mounting brackets.
Screw
The display
8.5 mm in
diameter or less
No gap
Washer
Mounting bracket
Non-threaded
part 4 mm
Mounting
bracket and
washer thickness
10-12 mm
[With M6 screws]
Screw
The display
10 mm in
diameter or less
No gap
Washer
Mounting bracket
Non-threaded
part 4 mm
Mounting
bracket and
washer thickness
15-17 mm
[With M8 screws]
(8) When installing the display on a wall or the ceiling, install a fall protection wire rope for safety.
(9) Never attach the display to a wall or the ceiling using only the fall protection wire rope.
(10) Install the fall protection wire rope not fully stretched.
When attaching the fall protection wire rope to the handles, use the handles shown in the picture below
depending on the orientation.
When attaching the fall protection wire rope to the speaker brackets, follow the method shown in the figure
below.
(Tightening torque 139 to 189 N•cm)
Fall protection wire rope position with landscape orientation
Fall protection wire rope position
with portrait orientation