12
Controls
–continued
*
: Trademarks apply to appropriate countries.
FINE (Analog input only)
Improves focus, clarity and image stability by increasing or decreasing this setting.
Should the “Auto Adjust function” and the “H.Size” function do not give you a satisfactory picture
setting, a fine tuning can be performed using the “Fine” function. It improves focus, clearity and
image stability by increasing or decreasing this setting.
For this a Moiré test pattern could be used. If the Fine value is wrongly calibrated, the result
would look like on the left drawing. The image should be homogeneous.
AUTO FINE (Analog input only)
This function automatically and periodically adjusts the "FINE" setting for change in signal condition.
This function adjusts approximately every 33 minutes or when a change in signal timing is detected.
AccuColor
®
* Control Systems (Color Control Systems)
AccuColor Control Systems:
Six color presets select the desired color setting. Color temperature
increases or decreases in each preset. (NATIVE color preset cannot be changed.)
NATIVE:
Original color presented by the LCD panel that is unadjustable.
Tools 1
SHARPNESS:
This function is digitally capable to keep crisp image at any timings. It is continuously
adjustable to get distinct image or soft one as you prefer, and set independently by different timings.
The number of adjustment steps is different depending on whether EXPANSION Mode is OFF, FULL
or ASPECT (1280 x 1024 is OFF Mode).
EXPANSION MODE:
Sets the zoom method.
FULL:
The image is expanded to 1280 x 1024, regardless of the resolution.
ASPECT:
The image is expanded without changing the aspect ratio.
OFF:
The image is not expanded.
CUSTOM (Digital input and Resolution of 1280 x 1024 only):
Select one of seven expansion rates. In this mode the resolution may be low and there may
be blank areas. This mode is for use with special video cards.
VIDEO DETECT:
Selects the method of video detection when more than one computer is connected.
FIRST DETECT:
The video input has to be switched to “FIRST DETECT” mode. When current
video input signal is not present, then the monitor searches for a video signal from the other
video input port. If the video signal is present in the other port, then the monitor switches the
video source input port to the new found video source automatically. The monitor will not
look for other video signals while the current video source is present.
LAST DETECT:
The video input has to be switched to the “LAST DETECT” mode. When the
monitor is displaying a signal from the current source and a new secondary source is
supplied to the monitor, then the monitor will automatically switch to the new video source.
When current video input signal is not present, then the monitor searches for a video signal
from the other video input port. If the video signal is present in the other port, then the
monitor switches the video source input port to the new found video source automatically.
NONE:
The Monitor will not search the other video input port unless the monitor is turned on.
DVI SELECTION:
This function selects the DVI input mode(Input 1). When the DVI selection has been
change, you must restart your computer.
OFF TIMER:
Monitor will automatically power-down when the end user has selected a pre-determined
amount of time.
When FINE value is wrong.
When FINE value is correct.
Содержание MultiSync LCD1880SX-BK
Страница 1: ...1 MultiSync LCD1880SX User s Manual ...
Страница 22: ...MultiSync LCD1880SX Manuel Utilisateur ...
