NEC MultiSync LCD1525VA, Руководство по обслуживанию

Страница: 7 / 109

1-4
Quick Start
To attach the MultiSync
®
LCD monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. For the PC: Connect the 15-pin mini D-SUB of the appropriate signal cable
to the connector of the display card in your system (Figure A.1) . Tighten all screws.
For the Mac: Connect the MultiSync LCD
1525V
™ Macintosh cable adapter to the computer
(Figure B.1)
. Attach the 15-pin mini D-SUB end of the appropriate signal cable to the
MultiSync LCD
1525V
Macintosh cable adapter (Figure B.1) . Tighten all screws.
NOTE: To obtain the MultiSync LCD
1525V
Macintosh cable adapter,
call NEC Technologies at (800) 820-1230.
Remove connector cover and cable cover on back of monitor.
3. Connect the 15-pin mini D-SUB of the video signal cable to the appropriate connector on
the back of the monitor (Figure C1) .
Place the Video Signal Cable under Clip A. Then place AC Adapter Cable under Clip B.
Replace connector cover and cable cover.
NOTE: Incorrect cable connections may result in irregular operation, damage
display quality/components of LCD module and/or shorten the module’s life.
4. Connect one end of the power cord to the MultiSync LCD Series monitor and the other
end to the power outlet (Figure D.1) .
5. Turn on the monitor (Figure E.1) and the computer.
6. To complete the setup of your MultiSync LCD monitor, use the following OSM
™
controls:
• Auto Adjust Contrast
• Auto Adjust
Refer to the
Controls
section of this User’s Manual for a full description of these OSM controls.
NOTE: For download information on the Windows ® 95/98 INF file for your MultiSync
LCD
1525V
monitor, refer to the
References
section of this User’s Manual.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User’s Manual.
3
Figure A.1 Figure B.1
15-pin
mini D-SUB
Mac Adapter
(not included)
15-pin
mini
D-SUB