English−81
SLOT MENU
SLOT POWER
Allows the monitor to supply power to an Option Board slot during power save mode or standby mode.
[AUTO]: Power is continuously supplied to the Option Board slot, even during power save and standby
modes.
Power to the Option Board slot stops during power save and standby modes, when there is no installed
device.
[ON]: Power is continuously supplied to the Option Board slot, even during power save and standby
modes.
[OFF]: Power to the Option Board slot stops during power save and standby modes.
NOTE:
If the option board is a computer, please set [SLOT POWER] to [AUTO] or [ON].
RESET
Resets all slot menu settings back to factory setting, except for [SLOT POWER].
*
1
: This function depends on which Option Board installed in the monitor. When changing the setting, turn the monitor’s main power.
*
2
: This function depends on which Option Board you are using. This function is only available when Option Board is installed.
*
3
: Some Option Boards may not show it correctly.
*
4
: If the option board is a computer, please also check the computer’s shutdown settings.
NETWORK
NETWORK MENU
NETWORK INFORMATION
Configures the monitor’s network settings either automatically or manually.
IP SETTING
When [AUTO] is selected, the IP address is automatically obtained from the DHCP server.
When [MANUAL] is selected, the network settings must be entered manually. Contact the Network
Administrator for this information.
NOTE:
Consult your network administrator for the IP address when [AUTO] is selected for [IP SETTING].
IP ADDRESS
Set the IP address for the monitor connected to the network when [MANUAL] is selected for [IP SETTING].
SUBNET MASK
Set the subnet mask data for the monitor connected to the network when [MANUAL] is selected for
[IP SETTING].
DEFAULT GATEWAY
Set the default gateway for the monitor connected to the network when [MANUAL] is selected for
[IP SETTING].
NOTE:
Enter [0.0.0.0] to delete the setting.
DNS
Set the IP addresses of DNS servers.
[AUTO]: The DHCP server which is connected to the monitor will automatically assign its IP address.
[MANUAL]: Manually enter the IP address of the DNS server which is connected to the monitor.
NOTE:
Consult your network administrator for the IP address when [AUTO] is selected for [DNS].
DNS PRIMARY
Enter the primary DNS server settings of the network connected to the monitor.
NOTE:
Enter [0.0.0.0] to delete the setting.
DNS SECONDARY
Enter the secondary DNS server settings of the network connected to the monitor.
NOTE:
Enter [0.0.0.0] to delete the setting.
MAC ADDRESS
Shows the monitor’s [MAC ADDRESS].
EXECUTE
Executes the network information settings.
NETWORK SECURITY
Individually enable or disable the networking component for monitor functions.
NOTE:
Please set “DISPLAY” to “ENABLE” when updating the firmware revision via the network.
DISPLAY
Enables or disables the network function for controlling the monitor remotely.
When disabled, these functions do not work: External Control, Mail, HTTP server, SNMP, Crestron, AMX,
PJLink.
COMPUTE MODULE
This function is not available.
APPLY
Apply the network security settings.
PING
Confirm successful connection with the network by communicating with a preset IP address.
IP ADDRESS
Sets an [IP ADDRESS] for sending [PING].
EXECUTE
Checks a reply can be sent to the monitor or not from the [IP ADDRESS] by sending [PING].
RESET
Resets all network menu settings back to factory setting, except for [NETWORK INFORMATION] and
[PING].
