Getting started
18
Getting started
This section describes the tasks you must complete before you use
your M155 DECT Messenger.
Location of the M155 and the charger
Do not place the M155 or the charger near:
water, moisture or damp areas;
heat sources, direct sunlight or inadequately ventilated areas;
devices that produce strong magnetic fields, electrical devices,
fluorescent lamps, computers, radios, television sets, fax machines
and telephone terminals;
areas where the equipment may be covered, penetrated by fluids
and where its ventilation is impaired;
areas where there is excessive dust, and areas subject to vibration,
shock or extreme temperature fluctuations;
within reach of small children.
Installing the charger and charging the M155
To install the charger, perform the following steps:
1. Place the charger on a flat, even surface.
2. Select the appropriate mains plug from the set of four supplied with
the charger/AC adapter and click the mains plug in place on the AC
adapter.
3. Connect the AC adapter to an electrical outlet.
4. Place the M155 on the charger (note that LED on the charger lights
up) – See
Figure 1: M155 in charger
.
Attention:
A switched off M155 automatically switches on
when placed on the charger.
When a completely discharged M155 is put on the
desktop charger, it can take up to 5 minutes before
the display is lit.
