21
1
2
2
2
2
Anamorphic lens holder screw
Tilt angle fixing screw
Z-direction
setscrew
Indication of Adjustment Directions
The following arrows are used in this manual to indicate the moving and rotating directions of the lens unit.
X-direction
(Horizontal)
Panning
(Right-/Leftward turn)
Tilting
(Up-/Downward turn)
Z-direction
(Longitudinal)
Y-direction
(Vertical)
Preparation:
Get the supplied Allen wrench and screws (hexagon socket head cap screws) ready.
햲
Loosen the z-direction setscrews located at either side
of the lens holder. Extend the side plates toward the
depth as far as they will go, then retighten the setscrew
on each side.
햳
Using the enclosed four Allen screws (M8 hexagon socket head
cap screws), mount the anamorphic lens holder to your projector
housing with its orientation as illustrated below.
* Shown in Fig. 1 below are the tapped holes to be used for mounting the lens holder
when you want to have the projector lens 'look down' while keeping the film plane
vertical, with (or without) the use of lens shift feature.
* Shown in Fig. 2 below are the tapped holes to be used for mounting the lens holder
when you want to have the lens 'look up' while keeping the film plane vertical, with the
use of lens shift feature.
[Fig. 1]
[Fig. 2]
