NEC iS15-2K, Руководство пользователя

Страница: 43 / 90

page 2.27
iS15-2K
Cinema Projector: User Manual 2. Installation
DVI-D Inputs
The projector can also accept signals from a variety of alternative sources, via the
two DVI-D inputs. An external image processing unit can be located close to source
equipment such as computers, video tape players and DVD players etc. Therefore,
only the projector needs to be located in the projection booth.
The two inputs can be configured for use as:
• two separate, individually selectable Single DVI-D inputs
• one Twin link DVI-D input
For short distances, a regular DVI-D cable may be used, but for distances greater
than 5 metres the
DigiLink high bandwidth optical connection system is
recommended.
EDID handshaking
If you are using a computer DVI card or other DVI source that obeys the EDID
handshaking protocol, then the card or source will automatically configure itself to
suit the projector.
If not, then you should refer to the documentation supplied with the DVI source to
manually set the resolution to 2048 x 1080 or the nearest suitable setting.
Notes
For more information about
input connectors see
Connections , in section 6.
Appendix .
For more information about
supported input formats see
Specification , in section 6.
Appendix .
Cable complexity and
interference can be reduced by
using the
Digilink high
bandwidth optical connection
system. Contact your dealer for
more information.
The resolution of the DMD fitted
to the projector is 2048 x 1080
pixels.
This projector does not perform
any image processing on
signals connected to the DVI-D
inputs - an external image
processor such as the MMS
1000 is recommended for this
purpose.
The MMS multimedia switcher
does not use EDID protocols,
therefore you should use the
MMS menus to manually set the
output resolution as follows:
• Switcher Options
→
Page 5
→ Output Resolution → 2k x 1k
(2048 x 1080)
DVI-D inputs
A and
B