CHAPTER 3 NOTES ON TARGET SYSTEM DESIGN
User’s Manual U16647EJ1V0UM
29
Table 3-1. KEL Connector Pin Functions
Pin No.
Signal Name
I/O
Description
A1 to A6
GND
−
Connect to GND
A7
DDI
IN
Data input
A8
DCK
IN
Clock input
A9
DMS
IN
Transfer mode selection input
A10
DDO
OUT
Data output
A11
DRST
IN
Reset input to on-chip debug unit
A12
RESET
IN
System reset input (leave open when not used)
Note 1
A13
FLMD0
IN
Flash mode input (leave open when not used)
Note 2
B1 to B10
GND
−
Connect to GND
B11
PORT0_IN
−
Connect to GND
B12
PORT1_IN
−
Connect to GND
B13
V
DD
−
Connect to V
DD
for on-chip debugging (for target system power ON
monitoring)
Notes 1.
This may be required if DRST of the target device is an alternate-function pin and the initial value
of the OCMD0 bit changes according to the reset source. (Refer to section
3.2.8 RESET
.)
2.
This is required when the target device incorporates flash memory.
3.3.2 MICTOR connector
When using the MICTOR connector as the IE connection connector, mount the following connector on the target
system.
2-767004-2: 38-pin type (sold separately)
Remark
The 2-767004-2 is a product of Tyco Electronics AMP K.K.
Figure 3-10 and Table 3-2 show the IE connector pin configuration and the pin functions, respectively. Input/output
is indicated as seen from the target device.
Figure 3-10. MICTOR Connector Pin Configuration
Ground
1 (position #1)
2 (position #2)
Orientation hole
37
38
(Top view)
2-767004-2
Target device
Top view
Содержание IE-V850E1-CD-NW
Страница 2: ...User s Manual U16647EJ1V0UM 2 MEMO...
