NEC I-Select TW100, Руководство пользователя

Страница: 74 / 140

I-Select TS100 / I-Select TW100 User Guide - Upgrading Your System
4 - 10
Installing or Removing a 5.25-inch Device
This section of the chapter describes how to add and remove 5.25-inch devices. You
can install a DVD-ROM/ COMBO DVD-ROM CD-RW/ DVD+R9 Drive, tape backup
unit, or other 5-25 inch devices in the additional 5.25-inch bay. See the installation
instructions included with those items for specific installation information. Before
installing a 5.25-inch device, read section “Preparing the Device” on page 4-33.
Adding a 5.25-inch Device
1. Remove the right side door. See “Removing the Right Side Door” on page 4-4.
2. Remove the front panel. See “Removing the Front Panel” on page 4-6.
3. From the inside of the chassis, push on the desired slot cache with your left hand
and hold it with your right hand outside the chassis.
4. Pivot the cache until it gets released from the frame.
Note: The two tabs that hold the cache actually break: this
is normal.
5. Take two slide rails marked as “CD-ROM”. Slide rails come with the system in a
plastic bag.
6. Attach the slide rails to the upper holes on both side of the 5.25-inch device.
Figure 4 - 8 : Attaching the Slide Rails
7. Slide in the 5.25-inch device until hearing a click sound.
Figure 4 - 9 : Installing the 5.25-inch device
8. Connect the data cable to the device with the marked edge toward pin 1 of the
drive. See “Cabling the Device” on page 4-27.
9. Connect the power cable to the drive. See “Cabling the Device” on page 4-27.
10. Replace the front panel. See “Replacing the Front Panel” on page 4-6.
11. Replace the right side door. See “Replacing the Right Side Door” on page 4-5.
Note: Modify the BIOS Setup program to recognise the
additional device. For additional information, refer to the
‘Configuring your system’ chapter.