NEC EA294WMi-BK, Руководство пользователя

Страница: 8 / 30

English-6
Figure 1
Control
keys
Figure 2
Screws
Quick Start
To attach the Base to the LCD stand:
1. Place monitor face down on a non-abrasive surface ( Figure 1 ).
NOTE: Handle with care when monitor facing down, for avoiding damage to the front control
keys.
2. Please rotate the stand 90 degrees as shown in Figure 1 .
NOTE: Handle with care when pulling the stand.
3. Attach the base to the stand and lock screw at the base’s bottom ( Figure 2 ).
NOTE: Reverse this procedure if you need to re-pack the monitor.
To connect the LCD monitor to your system, follow these instructions:
NOTE: Make sure to read “Recommended Use” (page 3) before installation.
1. Turn off the power of your computer.
2. For a PC or MAC with DVI digital output: Connect the DVI signal cable to the connector
of the display card in your system ( Figure A.1 ). Tighten all screws.
For a PC with Analog output: Connect a 15-pin mini D-SUB signal cable to the
connector of the display card in your system ( Figure A.2 ).
For a MAC: Connect a Macintosh cable adapter (not included) to the computer, then attach the 15-pin mini D-SUB signal
cable to the Macintosh cable adapter ( Figure A.3 ).
NOTE: Some Macintosh systems do not require any Macintosh cable adapter.
For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display card in your system
( Figure A.4 ).
For a PC with HDMI output: Connect the HDMI cable to the connector of the display card in your system ( Figure A.5 ).
Figure A.1 Figure A.3
Macintosh Cable Adapter
(not included)
Figure A.2
DisplayPort cable
(not included)
Figure A.4 Figure A.5
HDMI cable
(not included)
NOTE: 1. Please use a DisplayPort cable with DisplayPort logo.
2. When removing the DisplayPort cable, hold down the top button to release the lock.