NEC DS1000, Описание продукта

Страница: 97 / 144

Section 3: Features
DS1000/2000 Product Description Section 3: Features
◆
89
3
System Timers, Trunks
Availability: All versions.
The system provides many trunk timers that the administrator
can customize. Review the table below for a description of each
trunk timer.
Table 8: Trunk Timers
Option Description
Line Response
When the system fails to detect loop current on a trunk, it will
wait this interval before marking the trunk as defective.
Dial Tone Detect When the system seizes a line to place a Speed Dial call, it waits
this interval for dial tone before outdialing the call.
PBX/Centrex Flash
Use this timer to set the Flash interval. When a user flashes a
trunk, the system opens the trunk circuit for this interval.
Force Idle (Trunk Guard
Time)
Use this timer to set the guard time for trunks. When the system
disconnects a trunk (e.g., after a user hang up), the system keeps
the line idle until this timer expires. The Trunk Guard Time helps
prevent call collisions.
Minimum Ring Detection
Timer
Use this timer to set the threshold for ring detection. If the ring
signal is longer than this interval, the system interprets the signal
as valid ringing. If the signal is equal to or shorter than this inter-
val, the system ignores the ringing.
DP Make Timer Use this timer to set the duration of the Dial Pulse Make signal
(i.e., relay closed). This is the “on” time in a Dial Pulse digit.
DP Break Timer
Use this timer to set the duration of the Dial Pulse Break signal
(i.e., relay open). This is the “off” time in a Dial Pulse digit.
DP Interdigit Timer Use this timer to set the duration of the Dial Pulse Interdigit sig-
nal (i.e., time between digits).
Manual DTMF Tone On
This timer sets the duration of DTMF digits for trunk calls man-
ually dialed by an extension user. This is required because the
system buffers the digits the user dials.
Manual DTMF Tone Off
This timer sets the duration of the interval between DTMF digits
for trunk calls manually dialed by an extension user. This is
required because the system buffers the digits the user dials.
Speed Dial DTMF Tone
On
This timer sets the duration of DTMF digits for Speed Dial trunk
calls automatically dialed by the system.
Speed Dial DTMF Tone
Off
This timer sets the duration of the quiet time between DTMF dig-
its for Speed Dial trunk calls automatically dialed by the system.
Loop Current Detection
Time
For loop start trunks, loop current must be present for this inter-
val before the system seizes the trunk.
Customize critical trunk
timers for compatibility with
the connected telco or PBX/
Centrex.