NEC DLP Cinema NC3200S, Руководство по установке

Страница: 48 / 194

2. Setting Up Your Projector
48
2.3.1 Lamp AC Power Supply Installation Specifications
The NC3200S series or the NC3240S series requires an AC power supply for the projector main
unit and an AC power supply for the lamp power supply. This section describes the work for the
AC power supply for the lamp power supply.
Warning
 Make sure to observe the contents described in this section.
 Entrust a specialist to carry out the power supply work from the power
supply equipment of the building to the place of projector installation.
 Work on the power supply is the responsibility of the worker who
performed the work. NEC shall accept no responsibility for problems
arising as a result of this work.
When using NC-32PS01
3-phase AC power supply equipment
- Do not use any voltage other than those shown below for the AC power supply connected to
the lamp power supply (NC-32PS01).
200 V AC to 230 V AC 3 phase power of 50/60 Hz or
380 V AC to 415 V AC 3 phase power of 50/60 Hz
- 3-phase AC power should be supplied from the three-phase three-wire power supply
equipment to the NC-32PS01.
Note that it is not necessary to connect neutral lines in this machine
Breaker
Lamp Power Supply
(NC-32PS01)
Input voltage
selection switch
3-phase AC power cable
3-phase AC power supply equipment
(Three-phase three-wire)