English-2
English
Locking tabs
Headphone
Figure C.1
Power Button
Figure TS.1
Figure R.1
Non-abrasive surface
Figure R.2
Figure R.3
4-SCREWS (M4)
(MAX depth: 10 mm)
If use other
screw, check
depth of hole.
Weight of LCD assembly: 4.3 kg - LCD193WM (MAX)
4.9 kg - LCD203WM (MAX)
5.3 kg - LCD223WM (MAX)
Specifications
Tighten all screws
100 mm
Thickness of Bracket
(Arm) 2.0 ~ 3.2 mm
Controls
OSD (On-Screen Display) control buttons on the front of the monitor function as follows:
1. Basic function at pressing each key
Showing OSD.
Shortcut to Bright adjust
window.
Button
At No OSD
showing
Shortcut to Volume adjust
window.
At OSD showing
(Icon selection stage)
Go to Adjustment stage.
Cursor goes to left.
Cursor goes to right.
At OSD showing
(Adjustment stage)
Go to Icon selection stage.
Adjust value decrease or
Cursor for adjust goes to
left.
Adjust value increase or
Cursor for adjust goes to
right.
SELECT
–
+
“Auto adjust” operate.
Reset operation.
Mute off/on switch on
Volume adjustment window.
AUTO/RESET
5. Turn on the monitor with the front power button and the computer
(
Figure C.1
).
6. No-touch Auto Adjust automatically adjusts the monitor to optimal
settings upon initial setup for most timings.
For further adjustments, use the following OSD controls:
•
Auto Adjust Contrast
•
Auto Adjust
Refer to the
Controls
section of this User’s Manual for a full
description of these OSD controls.
NOTE:
If you have any problem, please refer to the
Troubleshooting
section of this User’s Manual.
Tilt
Grasp both sides of the monitor screen with your hands and adjust
the tilt as desired (
Figure TS.1
).
Remove Monitor Stand for Mounting
To prepare the monitor for alternative mounting purposes:
1. Disconnect all cables.
2. Remove the hinge cover (
Figure R.1
).
3. Place monitor face down on a non-abrasive surface (
Figure R.1
).
4. Remove the 3 screws (LCD193WM) or the 4 screws (LCD203WM/
LCD223WM) connecting the monitor to the stand and remove the
stand as indicated (
Figure R.2
).
The monitor is now ready for mounting in an alternative manner.
5. Connect the AC cord and signal cable to the back of the monitor
(
Figure R.3
).
6. Reverse this process to re-attach stand.
NOTE:
Use only VESA-compatible alternative mounting method.
NOTE:
Handle with care when removing monitor stand.
Removing the Base
NOTE:
Always remove the Base when shipping
the LCD.
1. Place monitor face down on a non-
abrasive surface (
Figure R.1
).
2. While using your fingers, press the locking tabs to unlock the
Base.
3. Pull out the unlocked Base.
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm.
Please use the attached screws (4pcs) as shown in the picture when
installing. To meet the safety requirements, the monitor must be
mounted to an arm which guaranties the necessary stability under
consideration of the weight of the monitor.
The LCD monitor shall only be used with an approved arm (e.g. GS
mark).
3 screws (LCD193WM) -
4 screws (LCD203WM/LCD223WM)
4 x 12 mm with lock washer
and flat washer
M4
12 mm
100 mm
01_English
16/2/07, 8:01 AM
2
