NEC 1080Xd, Руководство пользователя

Страница: 182 / 216

5-10 I/O Board Installation
6.
Install the board in the slot.
7. Pivot the support bracket cover back into place and secure the pins in the
bracket ends (see Figure 5-8).
8.
Replace the access cover.
!
Insert the cover tabs into the slots in the chassis frame.
!
Press the cover to secure it. Replace the screw (see Figure 5-7).
9.
Carefully press all four rail latches (two on each side) and slowly slide the
chassis back into the cabinet (see Figure 5-9). Stop sliding if you feel
resistance and check for pinched or pulled cabling at the rear of the cabinet.
!
WARNING
Take care when releasing the latches and sliding the chassis
to avoid pinching your fingers.
A Two Rail Latches (right side shown)
Figure 5-9. Main Chassis Rail Latches
10.
Carefully and slowly slide the chassis all the way into the cabinet. Replace
the six chassis screws (see Figure 5-6).
Note:
If you need to connect any cables to the board,
do so before sliding the chassis all the way into the cabinet.
It might be easier to access board connectors with the
chassis forward.
A