6
Installation
1. Open the cover and insert two batteries of type AAA (LR03).
2. To enable
in passage delay
and
out passage delay
, remove the
jumper from the circuit board and place it over both pins as
shown on page 8.
3. Close the cover and fit the screw as shown on page 5.
Mount the door alarm as described on the next page.
4. If an external sensor shall be used, such as a a bed alarm or a
carpet sensor, insert the cable from the sensor to the connector
on the botton short side of the door alarm.
5. Turn on the power switch.
6. Connect the door alarm to an alarm receiver as described on
page 10 in this manual.
