NEAR 6XL, Инструкция по установке и эксплуатации

Страница: 9 / 16

5
Installation
Ventilation
The 6XL amplifier was designed to be placed on a table or rack-mounted. For rack-mounted applica-
tions, the amplifier(s) can be stacked one on top of the other for maximum use of the rack space
available without any extra, empty rack spaces between them.
An open air space of at least 4" must be provided at the front air intakes of the amplifier and the rear
exhaust must have at least 4" between itself and obstructions to ensure adequate cooling.
This
applies whether rack- or table-mounted.
Care should also be taken to ensure that the front intake air is not considerably warmer than the ambi-
ent air temperature. Mount the amplifiers low in the rack so that heat dissipation from other equipment
does not warm the amplifier's intake air.
Rack Mounting
Rack ears are included with the amplifier to allow
mounting in 19" racks. Attach the rack ears as shown
in the Mechanical Components section. If any feet
have been attached to the bottom of the amplifier,
remove them. Load the amplifier into the rack and
secure it to the rack with appropriate hardware (not
included).
Rear Rack Mounting
(Optional accessory, not included)
For greater rear support when rack-mounting a 6XL
amplifier, the RPK86 Rack Mounting Kit can be
attached to the rear of the amplifier by following these
steps:
1. Remove and save the three rear-most cover
screws from the chassis side.
2. Position the rack attachment as shown.
3. Replace and tighten the three cover screws
to secure the rack attachments.
4. Repeat on opposite side of amplifier.
Table Mounting
Rubber Feet are provided with the amplifier to allow it to
be placed on a tabletop. Attach the included feet to the
bottom of the amplifier as shown. Attachment of the rack
ears to the unit is optional and purely aesthetic.