NDS ExpandOR, Руководство пользователя

Страница: 13 / 25

5
5
Receive
1. Press the power button until the ring illuminates.
ExpandOR can receive streaming surgical video of a patient in the operating room/ procedure room from an-
other ExpandOR in the hospital. This section explains how to accomplish this task.
The steps required to receive surgical video from another ExpandOR within the hospital are shown below. Pri-
or to operating the unit, please confirm with your IT department and verify that the unit’s parameters are set
for your intended use.
2. Press RECEIVE button on the front panel until the LED below it turns on.
5. Stop receiving by pressing the RECEIVE button as shown in Step 2 above. The RECEIVE LED turns off. If vid-
eo was being recorded, ending receive also ends video recording and the RECORD VIDEO LED is turned off.
3.
If you want to record the video stream and/or capture images, verify with your IT department that the
ExpandOR is setup for video streaming and/or capturing images. If it is, then proceed as shown below.
Start recording video by pressing the
RECORD VIDEO button, as shown below, until the LED below it turns
on. Stop recording video by pressing the RECORD VIDEO button until the LED below it turns off. See page
9 for more on
RECORD VIDEO .
4. Pressing the CAPTURE IMAGE button as shown below, causes the LED below it to flash. One image is cap-
tured per button press. See page 9 for more on CAPTURE IMAGE.