NDS Dometic TEMPRA TLB100, Руководство по эксплуатации

Страница: 15 / 299

EN
6. Establish the N-BUS network by connecting the batteries with appropriate cables equipped with RJ11 6C/6P
connectors .
11 Wire and fuse sizing
In order to properly dimension wiring and fuses, the distances and loads must be analysed. As it is not possible to
provide a unique figure valid for every application, the following examples are purely indicative.
Maximum wire cross-section Estimated maxi-
mum consumption
Length ≤ 2 m Length 2 m … 4 m Length ≥ 4 m
Fuse
20 A (refrigerator,
lights, water pump)
4 mm² 6 mm² 10 mm² 40 A
130 A (inverter with
coffee machine, and
hairdryer)
25 mm² 35 mm² 50 mm² 150 A
200 A (inverter with air
conditioner)
35 mm² 50 mm² 70 mm² 200 A
12 Operation
Note Always charge the battery completely before using it to its full potential.
Activation
By factory default setting, the battery is inactive mode. No voltage present at the terminals and to use it, it must be ac-
tivated and switched on.
fig.

on page 4
1. Push the DIP switch 6 to on position.
2. Press and hold the On/Off switch for 1 second.
The battery will be active when the LED indicator lights up.
Shutting down
The battery can be switched off in four different ways:
• With the display button.
• With the On/Off switch.
• With DIP switch 6.
• With the smartphone application.
fig.

on page 5
To turn the battery off at the display, press and hold the button until the message "Shutdown" is displayed. The
battery will turn off with the Bluetooth® function remaining active.
14