NISTA DEVICES GmbH 2013 © All Rights Reserved
23
8 Reset device to Factory Default
Configuration
IP Door phone can be reset to its Factory default configuration by using following actions:
1. Via WEB-Management interface ( See Chapter 7.8 in User Manual document)
2. By using the
hardware ‘Factory Default Settings’ switch ( See Figure 6-1 )
To set IP Door Phone to Factory Default Setting by using
hardware ‘Factory Default Settings’ switch:
•
Power off the device.
•
Put the switch to “DEFAULT” position.
•
Power on this device will restore the factory default.
o
LED Display can show the message “ Destination not set “ if Day or Night destinations not specified
and
device’s case is open. Close the unit case.
o
Wait until
LED Display Shows’ Set to default’ message a case is closed
•
Power off the device.
•
Put the switch back to “NORMAL” position
•
Power on the device
Figure 8-1 Factory Default Settings switch SW2
