Document Number
DCV-00202
Date Released
Oct. 2016
Revision Number/Security level
R01 S2
Retrofit G6+InvencoLink GVR Advantage (US) Installation Guide
4.3
Installation Procedure
This section follows from the Disassembly procedure above, and assumes the pump is still open.
References to “left-hand” and “right-hand” are as viewed into the pump on the Side you’re working on.
1. Install the pre-assembled EZ0408 PSU plate into the pump, in the cavity behind where the left-hand
CRIND door was. For Side One this is the PSU Plate Assembly that has just had the InvencoLink
converter installed:
a. Ensure the pump door is latched into the open position.
b. Place the plate into the cavity as shown (Fig. 3.1b), and align the two standoffs (Fig. 3.1a)
with the holes in the floor of the cavity:
Fig. 3.1a
– Standoff positions to align with dispenser
Fig. 3.1b
– Side One
Plate in position
Side Two
Standoffs for mounting
