NCR 7156, Руководство по установке и эксплуатации

Страница: 26 / 38

Chapter 2: Setting Up and Using the Printer 7156 Setup and User’s Guide
September 1998 20
Validating and Verifying Checks
Note: If the MICR check reader feature is present, checks are verified then
validated.
1.
Insert the check from the front and place it on the slip table face down as
shown in the illustration on the facing page.
2.
Slide the check to the right until it lines up against the guide (wall).
3.
Slide the check toward the back of the printer until it contacts the form stop (it
won’t be able to go any further);
Or, align the check with any preset mark you may have made on the slip table.
The green LED on the slip table turns on when the form or check is properly
inserted (it has to cover two sensors on the slip table).
4. Follow the instructions from the host computer.
If the MICR check reader feature is present, the check is fed in and out while
the check numbers are read. If the check is verified as good, it is then
validated. If the check is not verified as good, it is not validated.
Note: Do not hold or keep the check from moving during the MICR check reader
transaction or the check numbers will not be read accurately.
5. Remove the check after it has been fed all the way back out.
6.
Follow the instructions from the host computer to finish the transaction.