4
TCP Notification Setup
Select the Send Notification via TCP radio button. A window will appear allowing
you to enter the destination IP address and Port Number. A listener application will
need to be present at that location listening on the specified port number.
UDP Notification Setup
Select the Send Notification via UDP radio button. A window will appear with
three variables: a checkbox for Use UDP broadcast, a Server IP, and a Port. When
Use UDP broadcast is checked and device on the network can receive the broadcast
since the IP is set to 255.255.255.255. When not checked you must specify a
specific Server IP address. A port number must be specified in the Port text box,
your listener application(s) will need to listen for USP broadcasts on this port
number.
Step 7:
Click the Save to WiFly button. You will see several commands exchanged
between Base Station and the WiFi module in the Log window. At the end you should
see Associated, and then farther down a line that says IP = the address next to this line
will be the IP address of your module. If a Static IP address was assigned it will say
using specified static IP. You should also now see the Green LED on you WiFi
module flashing slowly which means it is associated with your network.
Step 8:
Close Base Station. Disconnect the Zigmo from your computer. Remove the
WiFi module from the Zigmo configuration board. With no power applied install the
WiFi module into your Push Notification series controller, then to apply power using a
regulated 12VDC power supply (see Power Supply specifications section under
Hardware Reference for more info on Power supply requirements). You should see
the busy and ready LEDs on the PM controller turn on solid initially, after a moment
you will see them flash as well as the amber LED on the WiFi module, once this
flashing stops and the Ready LED on the controller turns on solid you are ready.
