NC ENGINEERING MKII 600 Series, Инструкция по эксплуатации, техническому обслуживанию и безопасности, Страница: 26 / 80

26
DANGER: ‐
ALWAYS use the body prop when carrying out any maintenance under the body.
ALWAYS empty the trailer before using the body prop.
NEVER enter the danger zone between the door and rear chassis without engaging the
door prop pins.
ALWAYS ensure hydraulic oil is depressurised and cooled before carrying out
maintenance.
Body Prop
Before carrying out any maintenance under the body: ‐
1) Ensure body is empty.
2) Raise body using tipping cylinder to approximately 30 degrees.
3) Stop tractor, apply the park brake and remove the key.
4) Remove locking pin from the body prop and lift the prop from the storage
position until it is resting against the back stop
5) Lower the body slowly until its weight is resting on the prop
To lower the body, reverse the above procedure and secure the prop using the pins.
Door Prop
Before carrying out any maintenance to the door or in the surrounding area ensure the door
pins are engaged: ‐
1) Fully close the door.
2) Stop tractor, apply the park brake and remove the key.
3) Remove R ‐ clip for prop pin.
4) Move prop pin from storage position and place into locking position.
5) Refit R ‐ clip
6) Repeat at the opposite side of the trailer.
To lower the door, reverse the above procedure.