10
STATUS
The LB800 uses ten discrete LED drivers, one for each zone. By performing a STATUS from the menu, the
drivers are queried for their status and return with their respective unique UID number, which is valuable
for programming the LB800 via RDM.
FACTORY RESET
This menu option is designed primary for rental facilities, as it clears all presets and returns the unit to
LOCAL Mode, with all values set at 0. FACTORY RESET should be performed only by qualified personnel.
Connections
Wired DMX Connections
LB800 uses industry-standard 5-Pin XLR male and female connectors to receive and forward DMX
signals and output RDM signals. The DMX port is self-terminating and does not require external DMX
termination when used in a chain. If the unit is the last device on a DMX chain, make sure that there is no
cable inserted into the DMX Out connector.
The DMX pin wiring is as follows:
• Pin 1: Signal Common
• Pin 2: Data –
• Pin 3: Data +
• Pin 4: Spare
• Pin 5: Spare
Wireless DMX Control
The LB800 built-in wireless receiver runs on CRMX / Lumen Radio protocol which can receive signals from
CRMX and some WDMX transmitters. Please note that each fixture can only be linked to a single network
at a time, and maintains the network ID of its previous linking. Therefore, the fixture’s linking data must be
cleared prior to linking to a new network.
To unlink LB800 fixture, follow these steps:
1. Push and hold the large knob on the control panel for 3 seconds. Release.
2. Rotate the large knob until the display shows SETTINGS highlighted. Push to select.
3. Make sure the UNLINK RADIO menu option is highlighted, and select. The Control Display will flash for
10 seconds, and the Radio is ready for linking to a transmitter, clearing the network memory in the fixture.
Optionally the radio can be turned off by selecting the RADIO OFF menu item.
