NaxerTech NTT-101, Руководство пользователя

Страница: 4 / 19

Naxer Tech
Limited
4 | P a g e
GPRS Initialisation
Format
%[CID] INO , GPRS Dial No ,APN, UserID , Pasword , UnitID , Control Center IP , Control Center
Port , Max Speed , CCIP2 , CCPort2
CID
CID refers to Command Identification, a randomly created 8-digit command tag. (Max 8
digits)
INO Command
GRPS Dial No. SIM GPRS dialing number. (Max 15 characters) Usually not required
APN GSM Operator GPRSAPN. (Max 31 characters)
User ID SIM User ID for GPRS Access. (Max 15 characters)
Password GSM Operator Password for GPRS Access (Max 15 characters)
Unit ID Identification tag for GPRS device, issued by Control Base.
Control Center Domain/IP Domain Name/IP address for GPRS data exchange at Control Base. (Max 15 characters)
Control Center Port Port number for GPRS data exchange with Control Base. (Max 15 characters)
Max Speed Over speed limit. (Min 0km/h Max 250km/h)
CC Domain/IP 2 Backup Domain Name/IP address for GPRS data exchange.
CC Port Backup port number for GPRS data exchange.
Example
%25900213I NO , *99# , Internet ,Telenor,Telenor, 00000001 , gprs.naxertech.com , 6081 , 180 , 203.
81.81.92 , 6081
Command Identification 25900213
GPRS Dial No *99#
APN Internet
User ID Telenor
Password Telenor
Unit ID 00000001
Control Center Domain pegasus.naxertech.com
Control Center Port 6081
Max Speed 180 k m/h
CCIP 2 203.81.81.92
CC Port 6081
If max speed violation occurs, the device will send GPS data and status of the Control Base
through GPRS or SMS (backup). The Control Base shall return a PDU packet containing address
details and alert test in order to let the device send the text message to authorized contact
number. If no GPRS connection can be established, the SMS terminal at the Control Base shall
send SMS messages to authorized contact numbers itself.
%GPRS,0 Configure device to send data SMS if GPRS connection cannot be established at all occasions.
%GPRS,1
Configure device to send data only through GPRS. SMS fallback will only be used in case of
alarms.
Note:

When entering INI/ INO commands leave unassigned parameters empty but always include the comma. (,)

In all the commands there is no space after the comma.

Control Center Number and Unit ID issued by the Control Base software cannot be changed after the initial %INI/ %INO
commands have been implemented.

Any further initializations with changes in Control Center Number have to be sent using the original GSM n umber, before you can
switch to a new Control Center Number.