7
|
P a g e
Installation
The Tracking Unit can operate on both 12V, 24V and 36V with negative earth (Negative to body).
Before starting installation, disconnect the vehicle battery and observe other manufacturers safety instructions regarding alarm systems,
airbags or anti theft radio coding.
If you want to install the Tracking Unit in the passenger compartment, make sure that all antenna cables and wiring is protected from
sharp edges and is routed in such a manner that it will not be pinched.
The device comes with GPS & GSM external antennas. Note that GPS external antenna should be facing to sky. GPS will not lock if GPS
antenna is placed beneath metal or metallic glass coatings.
The SOS button should be installed at a place on the dashboard. It should be hidden but easily accessed in emergency cases. It should be
placed separate from dashboard controls and car audio devices.
The installation position should be protected from water.
The joints should be bundled with insulation tape to avoid crush and short circuit.
Do not connect the spare battery to the Tracking Unit before you have completed all electrical wiring and connections to the device.
Do not mount the Tracking Unit or external GSM antenna in close to sound system.
NOTE:
9
Input power must be at a minimum of 8 V & must not exceed 37V. Direct connection with vehicle’s fuse box is preferred. NTT‐101 has
built‐in fuse for up to 30V input voltage protection.
9
Main
power
source
as
well
as
backup
battery,
both
must
be
connected
to
properly
initialize
the
Tracking
Unit.
9
Power
source
must
not
be
exceeding
30V
and
ground
cable
must
be
properly
connected
with
body
earth.
9
Cable
connector
(14
pin)
should
be
firmly
connected
into
the
Tracking
Unit
in
the
right
direction
as
shown
in
the
picture.
9
Please
note
that
installation
methods
may
vary
between
vehicle
models.
For
expert
wiring
and
connecting
please
contact
a
professional
car
electronics
workshop
for
installation
support
and
maintenance.
9
Choose
a
proper
position
to
install
the
terminal.
9
Remove
the
components
of
vehicle
correctly
during
installation.
9
Lay
and
bundle
the
vehicle
cables
as
the
original
direction.
9
Protect
the
joints
with
insulating
tape.(withstands
600v
)
To obtain maximum functionality of your Vehicle Tracking Unit you should locate and connect the following electrical output and input wires from
the vehicle to the complying pigtails of the device connector:
2 cables from DC Power Supply (+ from Vehicle Battery) and Ground
1 cable to SOS Emergency Button (Dry Contact)
1 cable to alarm siren or indicators
1 cable from Ignition ACC Out (from ACC+)
When connecting, refer to the cable description and wiring diagrams on the following pages.
14
Pin
Connecter,
Clip
side
downward
Pin
7
Pin
14
Pin
1
Pin
8
14
Pin
Jack
Make
sure
clip
side
is
downwards
Содержание NTT-101
Страница 13: ...13 P a g e...
