Naxa NT-5501, Инструкция по эксплуатации

Страница: 16 / 16

Troubleshooting
25
If you have any problems , check the list of common problems listed below.
The following symptoms may have caused by inappropriate adjustment rather than act-
ual malfunction of the unit. If the trouble persists, contact the service center.
Symptoms ible solutions
lease check to ensure the power cord is plugged in.
the power cord, and plug it in again after
seconds . restart the
lease check antenna connection.
S tations may problems pleas e tune to
another station to test reception .
Adjust the s ettings of contrast and brightness if needed .
lease increase the volume.
our may be in mute mode. ress button on the
remote control.
lease check other sound settings and connections.
lease check the antenna connection.
value may be set too high. R estart computer and
enter safe mode, then set monitor parameters to correct
value according to adjustment description.
S ample phase may be de cted, adjust phase acc ording to
picture position.
This product is the high resolution display device . A
few cell defects can occur in the manufacture of the
S ever al colored dots visible on the screen are accep table
per our quality standards, which are in line with other
manufacturers . This would would mean the is not
faulty. We hope you will unders tand that, per these
s tandards, the will not be changed or refunded.
Snowy
A snowy picture is usually due to weak signal. Adjust
your antenna or install an antenna
Double Image or
Double images are usually caused by s from
tall buildings. Adjust the direction of your antenna ,
or raise it higher above ground .
Radio Wave Interference
Wave patterns moving on the sc reen are usually
caused by nearby radio transmitters or short-wave
receiving equipment.
High Temperature Elec trothermal Interference
Diagonal or herringbone patterns may appear on the
screen, or part of the screen image may be missing.
This can be caus ed by high-temperature electrothermal
equipment in a ne arby laboratory or hospital.
26
No Power
No Picture
Good Picture
but no Sound
Good sound but abnormal
color or no picture
Remote control
not responding
under VGA input
Horizontal stripes
under VGA input
Colored dots may be
present on the screen.
Batteries of the remote control may be dead. Test by replacing
to a new set of batteries.
Clean the remote control lens. The distance between the LED
TV and remote control should be within 25 feet.