Naxa NPB-250, Инструкция по эксплуатации, Страница: 14 / 22

Page 14 Naxa Electronics
Programming a Playlist
When the CD is stopped, you can select up to 20 CD
tracks to play in any order that you choose.
1. Press the STOP key [11] to make sure that playback
has stopped.
2. Press the PROG/EQ key [12]. The LCD screen [17] will
flash “P-01”.
3. Use the SKIP UP or SKIP DN keys [3, 2] to choose a
track to enter into the playlist. You may also use
the +10/ALBUM key [13] to choose a track.
4. Press the PROG/EQ key [12] to save the track into
the playlist. The LCD display [3] will then flash the
next playlist track number (e.g., “P-02”).
5. Repeat steps 3 and 4 until your playlist is complete.
6. Press the PLAY/PAUSE key [4]. Play will start from
the first track in the playlist and stop once all of
the programmed tracks have been played.
7. Press the STOP key [11] to stop the programmed
playlist, then press the STOP key [11] a second time
to clear the playlist from Program memory.
Using the AUX Input
Set the FUNCTION switch [20] to the CD/AUX position
to play devices connected to the AUX Input jack [22].
1. Connect the audio source to the player. Use an op-
tional audio patch cable to connect the 3.5mm
headphone or line-out jack of the audio source to
the 3.5mm AUX Input jack [22] found on the rear of
the player.
2. Prepare the player. Set the FUNCTION switch [20]
to the CD/MP3/AUX position. Turn the VOLUME dial
[1] to lower the volume level.
3. Prepare the audio source. Start playback on the
device. Set the volume level of the device to ap-
proximately 80% of its maximum.
4. Adjust the final volume. Turn the VOLUME dial [1] of
the player to set the volume to a comfortable level.
⚠ L
Use the audio source to control playback
(e.g., stop, play, next). Use the player to
control the volume.