Navman iCN
4
3
Installing the iCN into your vehicle
The iCN can be mounted in
three different ways:
By suction straight onto the
windshield
By suction or an adhesive
disc onto the dash;
By directly screwing onto the
dash (iCN 630 only).
For detailed information on
using options 2 and 3, refer to
the User Manual, Installing the
iCN into your Vehicle.
Follow the safety guidelines to
ensure that the iCN does not
obstruct the view of the driver,
or interfere with the operation
of any airbags and safety
devices in the vehicle.
Suction mount
1. Choose a position on the
windshield where the iCN
will be clearly visible by the
driver without obstructing
the view of the road.
2. Thoroughly clean and dry
the suction cup and the
windshield.
3. Hold the suction cup firmly
against the windshield and
press the lever down until it
snaps close.
4. The ball foot should now
be securely fixed on the
windshield. Slip the locking
nut loosely over the ball
foot, with the flat side facing
upwards.
5. Snap the socket clip onto
the ball foot.
6. Adjust the position of the
socket clip, so that the iCN
will be clearly visible by the
driver.
7. Wind the locking nut onto
the thread of the socket clip
until firm.
8. Snap the iCN onto the
socket clip. First, position
the two locating tabs on the
underside of the iCN into the
corresponding slots on the
socket clip. Then snap the
upper side of the iCN into
the clip.
9. Flip the GPS antenna
outwards so that the
antenna is pointing
horizontally.
10. Plug the power adaptor
into the vehicles cigarette
lighter socket.
11. Plug the other end of
the power cable into the
socket on the left hand
side of the iCN.
12. Make sure that the iCN is
positioned such that the
GPS antenna has a clear
view of the sky.
You are now ready to enter
in your destination and start
navigating.
English
