6
Halo QUBE 2
|
Installation Guide V1.0
Installation
Location / Mounting
Install the Qube 2:
•
Under the driver or passenger’s seat
•
In or under the dash
•
In the boot / trunk area
The chosen location should:
•
Allow for later connection of the MDT or PDT.
•
Be dry
•
Not have excessive vibration.
•
Not be excessively hot.
•
Allow the antennas and cabling to easily connect to the Qube 2.
•
Allow the diagnostics LED’s can be seen
•
Allow sufficient clearance to plug and unplug Qube 2, while mounted.
Mount the unit using the supplied self-tapping screws and washers, placed through the slots in the
side rails. The side mounting rails are supplied fitted to the Qube 2 ready for installation. If a different
side mounting format is required, the mounting rails may be turned over or removed completely.
There are two types of mounting rails. Type A will clip and unclip from the side of the Qube 2 by
applying pressure on the foot of the mounting rail. Type B requires the end cap to be removed, and
the rails slid out to change their orientation. Only one type will be supplied with the unit.
Connect the antenna cables to the correct connector. Both the Cellular connector (TNC) and the
GPS (SMA) are screw on connectors, which should be hand tightened only. Connect the DB15
connector to the socket and hand tighten the two locking screws.
Ensure all cables are secured out of the way, so they will not be damaged, walked on, or have other
articles placed on them.
Important Notice
•
Before you begin ensure that drilling will not damage the vehicles structure, wiring or
equipment.
•
Ensure the Qube 2 cables, mounting screws etc will pose no hazard to the occupants of the
vehicle.
