Navman Fish 4350, Инструкция по установке и эксплуатации

Страница: 24 / 30

FISH 4350 / 4380 Installation and Operation Manual 24
NAVMAN
6-6 Cleaning and maintenance
Clean the screen only with a damp cloth and mild
detergent when dirty or covered in sea salt. Avoid
abrasive cleaners, petrol or other solvents.
Cover or remove a transom-mounted
transducer when repainting the hull. If painting
over a through hull transducer with antifouling
paint, use only one coat of paint. Remove the
previous coat of antifouling paint by sanding it
lightly.To optimize performance, avoid walking
on or jamming cables and connectors. Keep the
transducer free of weed, paint and debris. Do not
use a high pressure water blast on a speed sensor
paddlewheel as it may damage the bearings.
When not in use, the FISH 4350 or FISH 4380
can be removed from the installation bracket and
stored in the Navman carry bag, or
left on the
installation bracket and securely covered with
the sun cover.
Depth range
•
2 ft (0.6 m) to 600 ft (180 m).
Display type
•
TFT Colour.
•
Screen resolution 320 high x 240 wide
(pixels).
•
LED multi-level backlighting.
Supply voltage
•
10 to 16 V DC.
Supply current at 13.8 V
•
300 mA min - no backlighting.
•
400 mA max - full backlighting.
Output power
•
Variable, up to 200 W RMS.
Operating temperature
•
32° to 122°F (0° to 50°C)
Transom transducer cable length
•
FISH 4350 33 ft (10 m).
•
FISH 4380 26 ft (8 m).
Typical depth acquisition time from startup
•
2 seconds at 100 ft (30 m).
Receiver sensitivity
•
Better than 10 micro volts RMS.
•
Dynamic range 4.0 million to 1 (120 dB).
Temperature measurement range
Appendix A - Speci Þ cations
New Zealand and Australia (C Tick)
AS-NZS 3548.
· Environment: IP67.
NMEA Output (FISH 4380 only)
NMEA 0183 (Ver 2.0) 4800 baud is a standard for
interfacing marine electronic devices. The Navman
Þ sh Þ nder can output the following sentences:
•
DBT (Depth Below Transducer)
•
DPT (Depth and Keel offset)
•
MTW (Water temperature)
•
XDR (Battery voltage and fuel ß ow).
•
VHW (Speed)
Fuel Computer (FISH 4380 only)
(optional fuel transducer(s) required)
• Outboard carburetted two stroke and EFI
petrol/gasoline engines: 30 to 300 hp.
• Outboard four stroke petrol/gasoline
engines: 90 to 300 hp.
• Inboard petrol/gasoline engines: 50 to 300 hp.
• Minimum ß ow rate: 1.3 U.S. gallons per
hour (5 litres per hour).
• Maximum ß ow rate: 34 U.S. gallons per
hour (130 litres per hour).
FISH 4350 and FISH 4380
5.0" (126.0 mm)
3.5" (88.5 mm)
1.1" (27.9 mm)
5.7" (143.5 mm)
5.0" (126.0 mm)
FISH 4350: 89 mm (3.5")
1.2" (30.5 mm)
FISH 4380: 97 mm (3.8")
•
32° to 99.9°F (0°
to 37.7°C)
Resolution of
0.1° unit.
Transducer
frequency
•
200 kHz.
Speed range
•
1 to 50 kn (57.5
mph, 96.6 kph).
Standards
Compliance
•
EMC:USA FCC
Part 15 Class B.
Europe (CE)
EN50081-1 and
EN50082-1